With this antenna you increase the range of I2C radio transmitter.
This antenna can instead of, the kit supplied wire antenna be mounted on the board.
A spacer bolt, screw and nut are included.
| 1 | Rod antenna for fixed mounting |
| 1 | Distance Bolts M3 x 8 mm |
| 1 | Screw M3 x 16 mm |
| 1 | washer M3 |
| 1 | lock washer M3 |
| 1 | nut M3 |
Kit I2C radio transmitter for DIN rail mounting this 433 MHz radio transmitter allows you remote-controlled electrical socket controlled via the I2C bus.
Rod antenna for 433 MHz transmitter This antenna can be mounted outside the switchbox.
I2C bus length up to 200m per data sheet with the P82B96. The kit includes all required components and the circuit board.
Kit I2C WLAN module for the WEMOS-D1 on DIN rail With this WLAN module you can control I2C modules via the WLAN.
Kit I2C-Repeater with switch for Raspberry PI Level Translating from 3.3 V to 5 V for GPIO ports SDA and SCL
I2C output board with transistor amplifiers 8- bit digital All components required for the I2C output board including 8 power transistors BD135 (invers) or BD136 (normal) Switching capacity max. 45V 1.5A
Kit switching power supply control board 5V / 1A for DIN rail This 5V switching power supply control board I2C modules can be supplied with power.
Longer I2C bus wires with the P82B715 The kit includes all required components and the circuit board.
Rod antenna for 433 MHz transmitter This antenna can be mounted outside the switchbox.
Level translating and I2C-bus repeater with PCA9517 The kit includes all required components and the circuit board.
Digital I2C input card with optocouplers 8-bit 5-24V for DIN rail The I2C input module can be used to read 8 digital signals from 2.5V to 30V via the I2C bus. The inputs are galvanically isolated with optocouplers
Kit I2C output card digital 8-bit 5-24V for DIN rail With the I2C output card 8 digital loads can be switched. The output driver turns UDN2981 a positive voltage up to 30V.
Simulator Panel Voltmeter Module 6 analog measurements 0-30V Digital display for six 0-30V analog values for connection to the analog output card.
The I2C-coupler converts the V24 signals of the serial interface (RS232) in 5V signals for the I2C hardware. The kit includes all required components and the circuit board.
Kit I2C analog input card 8 channel 10 bit for DIN-rail With the I2C analog input card 5 analog signals of 0-10 V can be read.
Kit I2C multiplexer for DIN rail mounting With the I2C multiplexer, it is possible multiple I2C slaves with the same bus address to connect to the I2C bus.
Kit I2C input card digital 8-bit 5-24V for DIN rail With the I2C input module you can read 8 digital signals up to 30V.
