Kit I2C digital input Module
Kit I2C input card digital 8-bit 5-24V for DIN rail With the I2C input module you can read 8 digital signals up to 30V.
8-Bit expander for I2C-Bus
Kit I2C input card digital 8-bit 5-24V for DIN rail With the I2C input module you can read 8 digital signals up to 30V.
Kit I2C digital input board 8-bit with optocoupler and latch All components including the PCB
I2C output board with relay output stages 8- bit digital All components required for the I2C output board including 8 single-line relay 5V with integr. Free-wheeling diode. Switching capacity max. 200V AC 15W
Digital I2C input card with optocouplers 8-bit 5-24V for DIN rail The I2C input module can be used to read 8 digital signals from 2.5V to 30V via the I2C bus. The inputs are galvanically isolated with optocouplers
Digital I2C output card with optocouplers8-bit 5-24V for DIN rail With the I2C output card, 8 digital consumers can be switched.The output driver TBD62783APG switches a positive voltage up to 30V.
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
Review sent
Your review cannot be sent
Digital I2C output card with power transistors8-bit 5-24V for DIN rail With the I2C output card, 8 digital consumers can be switched.The power transistor BD676 can switch 40V 1A.
Mounting frame for DIN rail Set WAGO Mounting base for our I2C rails kits
Kit I2C-Repeater with switch for Raspberry PI Level Translating from 3.3 V to 5 V for GPIO ports SDA and SCL
Digital I2C input card with optocouplers 8-bit 5-24V for DIN rail The I2C input module can be used to read 8 digital signals from 2.5V to 30V via the I2C bus. The inputs are galvanically isolated with optocouplers
Set I2C bus connector 5-pin Accessories for I2C bus modules I2EOK, I2AOK, I2AT, I2AI18 Not suitable for I2HE, I2AH, I2HAE, I2HAA ...
Button for I2C-Repeater Accessories for I2C-Repeater I2RPI+T-FG
Programmed PIC for our I2C radio transmitter 433 MHz for DIN rail(I2HFS-Bk)
I2C clock and calendar chip, based on a 2048-bit static CMOS RAMIt can be used as clock or RTC for counting pulses are used.
I2C Bus Extender for longer lines at the I2C bus
Precision CMOS rail-to-rail input and output op amps
connect several I2C slaves with the same bus address on the I2C bus
Programmed PIC for our analog input module 8 channel 10 bit 250Hz (I2AE8-Bk)
digital temperature sensor with an I2C interface.
Programmed PIC for our analog output module 5 channel 10 bit (I2HAA-Bk)
I2C binary-coded decimal clock / calendar block with additional 56 bytes of NV-SRAMThe module provides data for seconds, minutes, hours, days, dates, months, and year. The last day of the month is adjusted automatically.
Programmed PIC for our analog input module 5 channel 10 bit (I2HAE-Bk)