Programmed PIC for our analog output module 5 channel 10 bit (I2HAA-Bk)
Kit I2C analog output card 4 channel 10 bit for DIN-rail With the I2C analog output card 4 analog control signals of 0-10 V can be output.
With the I2C-USB mode, you can access I2C slaves via the PC. The kit includes all required components and the printed circuit board on which the FTDI SMD chip is already installed.
Mounting frame for DIN rail Set WAGO Mounting base for our I2C rails kits
Digital I2C input card with optocouplers 8-bit 5-24V for DIN rail The I2C input module can be used to read 8 digital signals from 2.5V to 30V via the I2C bus. The inputs are galvanically isolated with optocouplers
Digital I2C output card with optocouplers8-bit 5-24V for DIN rail With the I2C output card, 8 digital consumers can be switched.The output driver TBD62783APG switches a positive voltage up to 30V.
Kit I2C output card digital 8-bit 5-24V for DIN rail With the I2C output card 8 digital loads can be switched. The output driver turns UDN2981 a positive voltage up to 30V.
Kit I2C-Repeater with switch for Raspberry PI Level Translating from 3.3 V to 5 V for GPIO ports SDA and SCL
Programmed PIC for our analog input module 5 channel 10 bit (I2HAE-Bk)
I2C Bus Extender for longer lines at the I2C bus
Programmed PIC for our I2C radio transmitter 433 MHz for DIN rail(I2HFS-Bk)
connect several I2C slaves with the same bus address on the I2C bus
I2C clock and calendar chip, based on a 2048-bit static CMOS RAMIt can be used as clock or RTC for counting pulses are used.
connect several I2C slaves with the same bus address on the I2C bus
